Things to note - MFG suggests to only run 500w burner when grain is in From 68F to 158F took about an hour or so (will use delayed start in future to make it that much easier) The heater switches both lite up and we could see it start to rise in temp pretty quickly. We set it to heat in manual mode, set temp for 10f over desired mash temp (148F + 10 = 158F) and turned on both heaters (500w+1500w) and hit Play button. If you want to learn more about water checkout our articles on water We put in the malt pipe and put the black plug over the pipe and we filled the cleaned unit with 6.4 gallons of filtered and treated water We wanted a 1.3 quarts of water per lb of grain ratioġ3.5lb grains x 1.3= 17.55 quarts divided by 4 to get 4.4 gallons of water However if you want you can do either a BIAB method or Batch sparging. On our batch we wanted to do a sparging technique we were used to and have a digiboil to heat extra water in so we did that and did our water calculations as follows. When cleaning it we figured out there is approximately just under 2 gallons of dead space below the bottom screen of the mash screen in malt pipe. Have any feedback on this article? We want to here from you! Click here to contact us with any feedback. Or simply email On The BrewZillaįirst things first get Water setup and heating Press play, it will heat to S1 temp and then hold that time, then heat to S2 temp and hold that time set, etc. Time and Temp and steps you don’t want just set a time of 0:00 and it will skip Press Play (this case it will hold temp for 10 hours and then heat for 2 hours to our strike temp) Press Auto, put it on S2, Press Temp set for your Strike temp (typically 10f over mash), Press Time set for a few hours (we do 2hrs) Press Time (set holding + past 30 seconds to get to hours for x (lets use 10) hours to delay not heating) Press temp (set +/-) to ambient or less (this is what it trys to go for when waiting so make sure its low) Press Auto (it should be on S1 on top let of screen) With the recirc arm (with included silicon tubing on it) we turned on the pump and tested that as well as got familiar with the ball valve for flow control to see what rates we would be recirculating the mash at.įor a Delayed Start (heating for next day) To turn on heating there are 2 rockers 500w and 1000w Press Temp and then Play/Pause button to start it Running the pump (with the return arm on) Manual mode (default mode) SEE CONTROL PANEL IMAGE BELOW Hold down Temp till it beeps (about 3 full seconds) When Plugged in Hit Power button to turn on Pro tip put on the return arm to clean pump and arm (see below) Rinse with water then do a PBW soak/wipe off and rinse again Īssembly is pretty easy per the instructions If you looking to buy one go here, if you have questions that are not addressed on the product page or here please email us at. The manufacturer's manual can be found at this link and mainly is centered around the V3.1.1, 35l 110v unit being used in the United States. This page is to serve as a practical guide to using it. The Brewzilla formerly known as the Robobrew has become a hugely popular product with great features at a great price.
0 Comments
Leave a Reply. |